Versions Compared
compared with
Key
- This line was added.
- This line was removed.
- Formatting was changed.
...
Mold Volume Factor
Note | ||
---|---|---|
| ||
The Mold Volume Factor, used to calculate the Wet Density of a One-Point test, is used in placed place of the actual Mold Volume. The Mold Volume Factor is determined by the following: Mold Volume Factor = 1 / Mold Volume The One-Point Wet Density Calculation differs from that of say, a Drive Cylinder: EXAMPLE Drive Cylinder The above One-Point math can be re-written as: |