Page Comparison

...

The following screen will appear if a gauge is calibrated to record 2 density readings. This is mainly used to support Troxler 3450 gauges.

Supply the both Density and Moisture values and Moisture value from your gauge
Click the Perform Test button
Review the standardization results
Save the standardization results if valid or re-enter the standardization data if data was entered in error

...

Tip

If the correct Gauge ID does not appear on the list, contact your MetaField Administrator to have it added.
On the Gauge Standardization screen, you will be prompted to enter 5 sets of Density and Moisture readings the first time you use a Gauge, and 1 set for each daily standardization thereafter.
Depending on the Gauge Category, you will need to enter Density Counts and Moisture Counts or Density Counts only. The Gauge Category is determined by you your MetaField Administrator.
Be sure to save your standardization results, otherwise the gauge will not be available when performing a density test that day.

...

Supply the Standardization Date
Supply the Density and Moisture Standard Counts Measured from the gauge
Click thePerform Testbuttonthe Perform Test button
Review the standardization results
Save the standardization results of valid or re-enter if data entered produced a standardization fail.

...

Versions Compared