...
| Warning |
|---|
| Standardization Date will not default to a date. Pay careful attention when entering this date. That date you enter must be >= the last standardization date you entered, so it is important you enter your standardization data in the order they were done. It is recommended that firms make it a practice of entering their standardization data as soon as possible (ideally on the job site after you run the standardization) and no later than the day the gauge was standardized. |
| Info |
|---|
The standardization is based on the the previous four (4) standardization counts along with the current values for that day. To determine if the moisture count passes, the absolute value of the following is evaluated: (New Moisture - Average Moisture) / Average Moisture <= gauge's Rx Moisture Limit / 100 To determine if the density (1 and 2) count passes, the absolute value of the following is evaluated: (New Density - Average Density) / Average Density) <= gauge's Rx Density Limit / 100 |
...