Page Comparison

...

Supply both Density and Moisture values from your gauge
Click the Perform Test button
Review the standardization results
Save the standardization results if valid or re-enter the standardization data if data was entered in error

Image RemovedImage Added

Tip

If the correct Gauge ID does not appear on the list, contact your MetaField Administrator to have it added.
On the Gauge Standardization screen, you will be prompted to enter 5 sets of Density and Moisture readings the first time you use a Gauge, and 1 set for each daily standardization thereafter.
Depending on the Gauge Category, you will need to enter Density Counts and Moisture Counts or Density Counts only. The Gauge Category is determined by your MetaField Administrator.
Be sure to save your standardization results, otherwise the gauge will not be available when performing a density test that day.

...

Supply the Standardization Date
Supply the Density and Moisture Standard Counts Measured from the gauge
Click the Perform Test button
Review the standardization results
Save the standardization results of valid or re-enter if data entered produced a standardization fail.

Image RemovedImage Added

Tip

title	Tip

If the correct Gauge ID does not appear on the list, contact your MetaField Administrator to have it added.
If the Calibration Date or Calibration Standard Counts appear incorrect, contact your MetaField Administrator.
Both Density and Moisture tests must pass for the gauge to become available for testing.

...

Versions Compared