Table of Contents | |
---|---|
|
...
Info | ||
---|---|---|
| ||
Only tests in the status of Complete or Pending can be reported. |
Status | Definition |
---|---|
Analyzed |
|
Pending |
|
Complete |
|
Review |
|
...
Info | ||
---|---|---|
| ||
Upon creating a density report, the option to include / exclude the Optimum Moisture Tolerance column on the report will be presented. |
Change Location / Change Proctor
You can perform a mass update of several test Locations or Proctor values by using the corresponding buttons in Quality Control.
To perform this action, select all the tests you would like to update and then choose either the Change Location or the Change Proctor button. After choosing a new Location or Proctor you will be prompted if you want to keep the exsting specifications or if you would like to update to possibly new values entered in Project Specifications. If you choose to keep the existing specifications, only the Location or Proctor value will be updated and your test results will be recalculated (Proctor updates only). If you choose to update the specifications, the system will look at Project Specifications to determine if the entered specifications should be overridden based on the new Location or Proctor value and the test results will be recalculated accordingly.
Warning |
---|
Changing the Location or Proctor Values as well as updating specification en masse cannot be undone. Be sure to verify that your Project Specifications and new Location / Proctor values are desired prior to performing this action. |
...
View Legend
...