Table of Contents |
---|
Setting Density Project Specifications
Blank Project Specifications
If any field is left blank, the defaults (global settings) specified within MetaField Administration will be used.
Field Instructions
- Any information added to this box will display to Field users for all Density Tests
Soil Density Test Specifications
- You can enter specific moisture and soil classification specifications on a project level or for a specific soil classification and/or loction
- Specifications entered here will be applied to Field as follows:
- System will look for a match on Location and Soil Classification
- System will look for a match on Location
- System will look for a match on Soil Classification
- System will look for a global project setting (no Location or Soil Classification)
- System will look at Admin settings
- These fields only apply to Soil Nuclear Gauge, Sand Cone or Moisture Content Tests
- Field users can override these default values in Field
- The table will load in the order that the system will look up a match from Field.
Field | Description |
---|---|
Location |
Filter Location List for Project If you have set locations on the General tab of Project Specifications for this project, by default the list of locations will be filtered to only those chosen. If you want to see the list of all locations, you need to remove this filter. |
Soil Classification |
|
Moisture Specification |
|
Lower/Upper Moisture % Tolerance |
|
Require Maximum Specified Compaction |
|
Minimum/Maximum Specified Compaction (%) |
|
Moisture Requires Retest |
|
Bituminous Density Test Specifications
Field | Description |
---|---|
Material |
|
Require Maximum Specified Compaction |
|
Minimum Specified Compaction (%) |
|
Maximum Specified Compaction (%) |
|
Required Retest |
|
Soil Density Project Specification Examples
Below are examples of how moisture and compaction settings will default in Field based on what is entered in Project Specifications and global settings in Admin.